Europa-1TechnologySoftwareEuropa ControlsGallerySupportAboutContactPre-order
Software

Open astronomy software with Europa-specific control around it.

Hover to preview • Click or tap to keep details open

OnStepX, INDI and KStars/Ekos are combined with a dedicated browser application for setup, mount tools and system administration.

WEB

Europa Web App

Responsive mount control, driver management, camera tools, firmware updates and tuning.

Explore details

Control the system from your browser.

The dedicated interface brings device management, mount commands and camera tools into a layout suited to phones, tablets and laptops. It is intended to help with setup and system checks alongside the astronomy software. Firmware, tuning and imaging tools depend on the installed release; request the current feature list before ordering.

Ask about current features →
INDI

INDI Server

Standard device-driver layer for cameras, mounts and accessories.

Explore details

A shared connection layer for astronomy equipment.

INDI drivers expose device controls to compatible client applications. Start the drivers needed for your equipment, then connect your client to the server. Camera and accessory support depends on the specific device, driver and software version. Check compatibility for your equipment before purchase.

Check equipment compatibility →
EKO

KStars / Ekos

Planning, capture, plate solving, guiding and sequencing.

Explore details

Plan targets and coordinate an imaging session.

KStars provides the sky-planning interface, while Ekos brings together equipment connection and imaging tools. A configured setup can use capture sequences, plate solving, guide-camera calibration and guiding. Each workflow requires the relevant hardware and software configuration; advanced automation availability should be confirmed for the supplied system.

Get software setup help →

Driver Manager

Launch and manage INDI device drivers.

Explore details

Start with the devices you actually need.

Select the mount, camera and accessory drivers for your setup, start the INDI server and check device availability before connecting an imaging client. This gives you a central place to check which drivers are running. Avoid running a second server on the same configured port.

Open support →

Mount Control

GOTO, Sync, Tracking, slew and home functions.

Explore details

Point, track and check mount status.

Mount tools bring together target coordinates, GOTO, synchronisation, tracking and manual axis movement. Confirm home position, time and location before a slew, and keep the telescope path clear. Synchronisation associates the current position with a known target; it does not replace physical polar alignment.

Read setup guidance →

Camera Manager

Camera connection, snapshot and preview tools.

Explore details

Check your camera before starting a sequence.

Connect the camera and use snapshot or preview tools to inspect framing and exposure. Available settings depend on the camera and INDI driver, including cooling controls where supported. Confirm the supplied release’s capture and preview capabilities for your camera model.

Check your camera →

Motor Optimisation

Axis current and performance tuning.

Explore details

Tune the drive for the actual observing setup.

Axis-current and movement settings affect motor behaviour and must match the controller, motors and mechanical configuration. Begin with the supplied settings and change one parameter at a time while recording the result. Contact support before changing parameters outside the recommended range.

Request tuning guidance →

Backlash Testing

Automated RA/DEC reversal tests and plots.

Explore details

Inspect behaviour when an axis reverses direction.

Reversal tests help investigate delay or lost movement when RA or DEC changes direction. Compare repeated measurements under consistent loading and settings before making adjustments. Test and plotting tools are release-dependent; a test result alone does not establish the guiding performance of the complete imaging setup.

Ask about reversal tests →

Time & Location

Integrated GPS/time workflow for astronomy services.

Explore details

Keep the observing coordinates consistent.

Correct time and site coordinates are needed for sky calculations and pointing. The GPS/time workflow helps check the system’s time and location and their agreement with the mount controller. Verify the reported position and time before observing, particularly after relocation or a period without a GPS fix.

Get time and GPS help →